Center Console 22'


The PROTECTOR  22′ Center Console is an open console design with a center steering position and a large, dry storage area below the console. The 22’ model offers comfortable seating for 4-6 people and an optional canvas T-top. Its multi-purpose, high-performance solid hull design is unprecedented in its category.

The Center Console’s solid laminate fiberglass hull is built for strength and safety and the chambered hypalon tubes provide shock absorption, stability and additional flotation. Together, the deep-V hull and UV-resistant tubes create unmatched safety and performance compared to traditional hard sided boat designs.

I’ve owned a ton of boats in this size range, however not one has ever come close to the ride quality and agility of the Protector 22′.



Length Overall: 23’2”
Waterline Length: 19’6”
Beam Inflated: 8’6”
Beam Deflated: 7’6”
Draft:  22” with average load
Weight: approx 2,500 lbs with motors, 2850 lbs fully loaded with fuel & equipment
Fuel Capacity: 47 gallons
Deadrise (aft/fwd):  23/60
Max Horsepower: 200 HP Single Outboard
Person Capacity: 7
Top Speed: 52+ MPH
Cruise Speed: 30 MPH
Range at Cruise: 145 NM


PROTECTOR Hypalon sponson with Armour Guard resistant rub rails and nose cone
Chambers: 5
Standard Colors: Black, Dark Grey, Red, Yellow, Dark Blue, White
Rescue line (black) along entire length of each sponson
2 Grab handles on aft end of rear sponsons
Port and stbd grab handles on bow sponson
Sponson pressure gauge

Console & Accessories

4” Diameter 316 SS Forward Sampson Post with Cross-pin
2” 316 SS Tow Post
12-volt power receptacle
Anti-corrosion sealant and marine grade shrink tube on all electrical connectors
LED Navigation & anchor lights
Lifeline Group 24 engine battery
Lifeline Group 36 house battery
BEP Battery switch on Lifeline Group 24 batteries w/ voltage sensitive relay module
Marine Grade SS Radar Arch for light bar / Radar / IR Camera (option)
House battery voltmeter
Lenco commercial trim tabs – auto retract gauge
Heavy Duty 316 SS PROTECTOR T-TOP with Sun-brella Canopy (option)
Isinglass clears around T-TOP for heavy weather protection (option)
Forward SS Sampson Post with handrails

Hull & Deck

3/4” solid hand-laid fiberglass hull with exclusive Protector High-Impact hull design
Proprietary sponson cutouts for sponson integration into hull
Solid 4 stringer system
Port and stbd self-bailing scupper caps
Port and stbd 2.5” self-bailing water drains fwd deck
6 performance strakes / chines along hull
316 SS bow towing eye
Self-draining anchor locker
1000 GPH manual bilge pump & 1100 GPH auto-bilge pump
Non-skid decks featuring rubber sure-foot flooring system
Open Console design for ease of electronics maintenance
Non-skid gunnel walking rails atop sponsons (option)


Pressure tested 47 gallonfuel tank
Longitudinal and transverse baffles in fuel tank
STBD fueling station at transom
Removable WEMA fuel sender for fuel tank cleaning and inspection


Teak Flooring
Stainless Steel lifting points / Stainless Steel Towing Eyes
On board charging system, 30AMP Shore Power, Inverter
Stowable teak table and aluminum pedestal
PROTECTOR Stainless Steel heavy duty radar arch for CC models
Underwater accent lights at transom
Courtesy lights at helm, rear deck, and cabin top
Mooring or Storage Tube Covers
Power Assisted hydraulic steering for Yamaha Outboards
Overhead electronic box mounted under T-Top